Thursday, August 21, 2008

na axles



hi all, i have been making axles these week. they are turned from brass. For those that need it a gear pressed on and soldered in place. the gear is cut from spur gear stock. hope to have a rolling chassie soon.




3 comments:

Unknown said...

Did you make the spur gear stock or buy it?

Unknown said...

Another comment since I just looked back at your intro. 5mm gauge? Which motor will you use?

elmhurst_motor said...

in reply, the spur stock was purchased, the motor is a 6mm g15 motor, there a cheap 3v pager motor with a reduction gearbox.